(6) For 100 V series As shown below, unlatch the power cord bush and pull it up from the AC
cord holder. Then release the power cord from the cable guides provided on the AC cord
holder (shown on
(7) Release the power supply shield from the lock and two stoppers on the lower PS/MJ frame
and pull it up.
(8) Disconnect the power supply harness from the power supply PCB.
(9) Remove three screws "c," take the power supply PCB and PS PCB insulator off the lower
PS/MJ frame, and then remove the power supply harness from the lower PS/MJ frame.
(10) For 100 V series Remove screw "a" and take the MJ shield off the lower PS/MJ frame.
For 200 V series Remove screw "a" (that secures the MJ shield and power inlet) and
screw "d" (that secures the grounding wire). Then take the MJ shield and power inlet off
the lower PS/MJ frame.
Note: If the EXT cap has not been removed, remove it beforehand.
(11) Remove the AC cord holder.
Note: If the AC cord holder has a band, cut it off.
(12) Disconnect the MJ (LINE) harness
release them from the cable guide on the MJ PCB insulator.
(13) Remove screw "b" and take the MJ PCB
frame.
MJ PCB *
Ferrite core(s) *
Power cord bush
Power cord
AC cord holder
Grounding wire
"a"
"d"
Power inlet
200 V series
page
3-87).
*1
and MJ (EXT) harness
"a"
1
"b"
CN1
CN2
2
Lower
PS/MJ frame
Lock
MJ shield
Ferrite core
3-85
*1
and MJ PCB insulator off the lower PS/MJ
MJ shield
*1 For MFC only
*2 Two ferrite cores on 100 V
1
MJ (LINE) harness *
(yellow)
1
MJ (EXT) harness *
(black)
MJ PCB insulator *
Cable guide
Latch
PS PCB
insulator
"c"
Stoppers
"a" and "e": Screw, bind M3x6
"b" and "c": Taptite, cup S M3x6
"d": Screw, pan (washer), M4x8DB
*1
from the MJ PCB
series with main PCB
B57U082
1
Power supply shield
Slit
"c"
"c"
Bent section
Power supply PCB
Power supply harness
Confidential
*1
and
(3_077)