Chapter 3 Disassembly And Assembly; Safety Precautions And Handling Notes - Brother DCPJ525W Service Manual
Hide thumbs
Also See for DCPJ525W:
- Basic user's manual (100 pages) ,
- Quick setup manual (32 pages) ,
- User manual (85 pages)
Table of Contents
Advertisement
CHAPTER 3 DISASSEMBLY AND ASSEMBLY
This chapter details procedures for disassembling and reassembling the machine together with related
notes. The disassembly order flow provided enables you to see at a glance the quickest way to get to
component(s) involved.
At the start of a disassembly job, you check the disassembly order flow that guides you through a
shortcut to the target components.
This chapter also covers screw tightening torques and lubrication points to which the specified
lubricants should be applied during reassembly jobs.
1
SAFETY PRECAUTIONS AND HANDLING NOTES
To prevent the creation of secondary problems by mishandling, observe the following
precautions during maintenance work.
WARNING
WARNING
Before replacing parts or units, unplug the power cord and telephone line*.
In particular, when having access to the power supply inside the machine, make sure that the
power cord is unplugged from the electrical outlet; when having access to the main PCB or
MJ PCB*, make sure that both the power cord and telephone line* are unplugged from the
electrical outlet.
(1) Be careful not to lose screws, washers, or other parts removed for parts replacement.
(2) When using soldering irons and other heat-generating tools, take care not to damage the
resin parts such as wires, PCBs, and covers.
(3) Static electricity charged in your body may damage electronic parts.
Before handling the PCBs, touch a metal portion of the machine to discharge static
electricity charged in your body. When transporting PCBs, be sure to wrap them in
conductive sheets.
When replacing the head/carriage unit, put on a grounding wrist band and perform the job
on a static mat. Also take care not to touch the conductor sections on the flat cables.
(4) Be sure to reinsert self-tapping screws correctly, if removed.
(5) Tighten screws to the torque values listed on the next page.
(6) When connecting or disconnecting cable connectors, hold the connector bodies not the
wires. If the connector has a lock, always slide the connector lock to unlock it.
(7) Before reassembly, apply the specified lubricant to the specified points. (Refer to
in this chapter.)
(8) After repairs, check not only the repaired portion but also that the connectors and other
related portions function properly before operation checks.
(9) Once the head/carriage unit prints, it will start head locking operation after five seconds
from the end of printing. The head locking operation will take 5 to 10 seconds. NEVER
unplug the power cord before the machine completes the head locking operation; doing so
will make the head/carriage unit unusable and require replacement with a new head/
carriage unit.
When you receive the machine from the user or when you pack it for sending it back to the
user, check the head locking state.
3-1
*
For MFC only
Section 5
Confidential
- Quick Links:
- Service Manual
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
