Firmware Switch Setting And Printout (Function Codes 10 And 11) (User-Accessible) - Brother DCPJ525W Service Manual
Hide thumbs
Also See for DCPJ525W:
- Basic user's manual (100 pages) ,
- Quick setup manual (32 pages) ,
- User manual (85 pages)
Table of Contents
Advertisement
1.4.6 Firmware Switch Setting and Printout (Function codes 10 and 11)
(User-accessible)
[ A ] Firmware switch setting
Function
The machine incorporates the firmware switch functions which can be activated with the
procedures using the control panel keys.
For details about the firmware switches, refer to the "Firmware Switches (WSW)" document
separately issued.
The firmware switches have been configured at the factory in conformity to the
communications standards and codes of each country. Do not disturb them unless necessary.
Some firmware switches may not be applicable in some versions. The firmware switch data list
indicates "Not used." for those inapplicable switches.
Operating Procedure
(1) Press the 1 and 0 keys in this order in the initial stage of the maintenance mode.
The machine displays the "WSW00" on the LCD and becomes ready to accept a firmware
switch number.
(2) Enter the desired number from the firmware switch numbers (01 through 60).
The following appears on the LCD:
(3) Use the
(4) Enter the desired number using the 0 and 1 keys.
(5) Press the OK key. This operation saves the newly entered selector values onto the
EEPROM and readies the machine for accepting a firmware switch number.
NOTE: Pressing the Stop/Exit key instead of the OK key returns the machine to the initial
stage of the maintenance mode without saving new setting.
(6) Repeat steps (2) through (5) until the modification for the desired firmware switches is
completed.
(7) Press the Stop/Exit key to return the machine to the initial stage of the maintenance mode.
NOTE: If there is a pause of more than one minute after a single-digit number is entered for
double-digit firmware switch numbers, the machine automatically returns to the initial stage of
the maintenance mode.
Selector 1
Selector 8
↓
WSWXX = 0 0 0 0 0 0 0 0
and
keys to move the cursor to the selector position to be modified.
↓
5-14
Confidential
- Quick Links:
- Service Manual
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
