Table of Contents
Advertisement
Periodic maintenance and adjustment
1. V-belt position adjusting bolt
2. Spacer
V-belt position
More than 1.5 mm
(0.06 in) above the
edge
From 1.5 mm (0.06 in)
above the edge to 0.5
mm (0.02 in) below
the edge
More than 0.5 mm
(0.02 in) below the
edge
7.
Tighten the V-belt position adjusting
bolts.
V-belt position adjusting bolt tightening
torque:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
8.
Install the V-belt over the primary sheave
assembly.
56
Adjustment
Remove spacer
Not necessary (It is
correct.)
Add spacer
9.
Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
1. Secondary sliding sheave
2. Secondary fixed sheave
10. Install the V-belt between the secondary
sliding and fixed sheaves.
1. V-belt
11. Install the drive guard, and then install the
left side cover and the shroud.
ESU12103
Drive chain housing
To check the drive chain housing oil level
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Remove the shroud and the right side
cover. (See page 41 for removal proce-
dures.)
3.
Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
Hide quick links:
Advertisement
Table of Contents
