Checking Electrical Connectors And Electrical Leads; Checking Propeller - Yamaha F4 Owner's Manual
Hide thumbs
Also See for F4:
- Service manual (308 pages) ,
- Owner's manual (174 pages) ,
- Brochure & specs (4 pages)
Table of Contents
Advertisement
Recommended engine oil:
YAMALUBE 4M FC-W or 4-stroke
outboard motor oil
Engine oil quantity:
0.6 L (0.63 US qt, 0.53 Imp.qt)
11. Wait 5-10 minutes until the oil settles.
12. Remove the oil filler cap and wipe the at-
tached oil dipstick clean.
13. Install the oil filler cap and tighten it com-
pletely.
14. Remove the oil filler cap again and check
that the oil level on the dipstick is be-
tween the upper and lower marks. If the
oil level is not at the proper level, add or
extract oil until the oil is between the up-
per and lower marks.
1. Oil dipstick
2. Upper mark
3. Lower mark
15. Install the top cowling.
16. Start the engine and make sure that
there are no oil leaks. NOTICE: If there
are oil leaks, stop the engine and find
the cause. Consult your Yamaha deal-
er if the problem cannot be located
and corrected. Continued operation
with a problem could cause severe
engine damage.
17. Dispose of used oil according to local
regulations.
1
2
3
ZMU06737
[ECM02151]
TIP:
For more information on the disposal of
used oil, consult your Yamaha dealer.
Change the oil more often when operating
the engine under adverse conditions such
as extended trolling.
EMU39773
Checking electrical connectors and
electrical leads
For checking of the following items for the
connectors and leads, consult a Yamaha
dealer.
Check that each connector is connected
securely.
Check that each ground lead is secured
properly.
EMU39303
Checking propeller
EWM02281
WARNING
You could be seriously injured if the en-
gine accidentally starts when you are near
the propeller. Before inspecting, remov-
ing, or installing the propeller, place the
gear shift lever in neutral, and remove the
clip from the engine shut-off switch.
Do not use your hand to hold the propeller
when loosening or tightening the propeller
nut. Put a wood block between the anti-cavi-
tation plate and the propeller to prevent the
propeller from turning.
Maintenance
ZMU06879
67
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
