Table of Contents
Advertisement
ECB00520
NOTICE
When tightening the locknut, hold the adjust-
ing bolt with a wrench so that it does not turn
together with the locknut.
Tightening torque:
Locknut (rear brake caliper):
16 Nm (1.6 m·kgf, 11 ft·lbf)
EWB02090
WARNING
Operating with improperly serviced or adjust-
ed brakes could cause the brakes to malfunc-
tion,
resulting
performance. This could increase the chance
of a collision or accident. After adjusting the
parking brake free play, block the rear of the
ATV off the ground and spin the rear wheels.
Check to make sure there is no brake drag. If
brake drag is noticed, perform the adjustment
again.
in
reduced
braking
EBU24740
Brake light switches
The operation of the brake light switches must be
checked and, if necessary, adjusted at the inter-
vals specified in the periodic maintenance and lu-
brication chart.
The brake light switch for the brake pedal can be
adjusted as follows, but the other brake light
switches should be adjusted by a Yamaha dealer.
TIP
The brake light switch is properly adjusted when
the brake light comes on just before braking takes
effect.
Turn the adjusting nut while holding the brake light
switch in place. To make the brake light come on
earlier, turn the adjusting nut in direction (a). To
make the brake light come on later, turn the adjust-
ing nut in direction (b).
8-27
8
- Quick Links:
- Engine Oil
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
