Adjusting The Self-Propel Drive; Cleaning Under The Machine - Toro 20332 Operator's Manual
22in recycler
Hide thumbs
Also See for 20332:
- Operator's manual (72 pages) ,
- Parts catalog (12 pages) ,
- Operator's manual (32 pages)
Table of Contents
Advertisement
Figure 30
Important: Position the curved ends of the blade
to point toward the mower housing.
6. Use a torque wrench to tighten the blade bolt to 82
N-m (60 ft-lb).
Important: A bolt torqued to 82 N-m (60 ft-lb) is
very tight. While holding the blade with a block
of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.
Adjusting the Self-Propel Drive
Whenever you install a new self-propel cable or if the
self-propel drive is out of adjustment, adjust the self-propel
drive.
1. Turn the adjustment knob counterclockwise to loosen
the cable adjustment
(Figure
31).
g027709
1. Handle (left side)
2. Adjustment knob
2. Adjust the tension on the cable
back or pushing it forward and holding that position.
Note: Push the cable toward the engine to increase
the traction; pull the cable away from the engine to
decrease the traction.
3. Turn the adjustment knob clockwise to tighten the
cable adjustment.
Note: Tighten the knob firmly by hand.
Cleaning under the Machine
Service Interval: Before each use or daily
WARNING
The machine may dislodge material from under the
machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the engine is running.
• Do not allow bystanders in the area.
For best results, clean the machine soon after you have
completed mowing.
1. Move the machine onto a flat paved surface.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Lower the machine to its lowest cutting-height setting;
refer to
Adjusting the Cutting Height (page
4. Wash out the area under the rear deflector where the
clippings go from the housing to the grass bag.
Note: Wash out the area with the bag-on-demand in
both the fully forward and fully rearward positions.
5. Attach a garden hose that is connected to a water
supply to the washout port
18
Figure 31
3. Self-propel-drive cable
(Figure
31) by pulling it
9).
(Figure
32).
Hide quick links:
Advertisement
Table of Contents
