Table of Contents
Advertisement
Figure 34
1. Alignment strip
2. Approximately 5 inches
(12.7 cm)
Note: Due to the nature of the power steering
system, the steering wheel will not return to its
original position after a turn has been completed.
Important: The machine should never be
stopped on a green with the cutting unit reels
operating as damage to the turf may result.
Stopping on a wet green with the machine may
leave marks or indentations from the wheels.
6. If the leak detector alarm sounds while cutting on
a green, immediately raise the cutting units, drive
directly off of the green and stop the machine in an
area away from the green. Determine the cause of
the alarm and correct the problem.
7. Finish cutting the green by mowing the outer
periphery. Be sure to change the direction of cutting
from the previous mowing. Always keep weather
and turf conditions in mind and be sure to change
the direction of mowing from the previous cutting.
Replace the flag.
8. Empty the grass baskets of all clippings before
transporting to the next green. Heavy wet clippings
place an undue strain on the baskets and will
add unnecessary weight to the machine, thereby
increasing the load on the engine, hydraulic system,
brakes, etc.
3. Cut grass on left
4. Keep focal spot 6-10 ft
(1.8-3 m) ahead of the
machine.
Leak Detector Operation
The leak detector alarm may sound for one of the
following reasons:
• A leak of 4 to 6 ounces (118-177 ml) has occurred.
• The oil level in the main reservoir is reduced by 4 to
6 ounces due to contraction of the oil by cooling.
If the alarm sounds, it should be turned off as quickly
as possible and inspected for leaks. If the alarm sounds
while operating on a green it may be appropriate
to drive off the green first. The source of the leak
should be determined and repaired before continuing
operation. If a leak is not found, and a false leak is
suspected, move the ignition switch to the Off position
and allow the machine to stand for 1-2 minutes to allow
the oil levels to stabilize. Then start the machine and
operate in a non-sensitive area to confirm no leak exists.
False alarms, due to oil contraction, may be caused by
extended idling of the machine after normal operation.
A false alarm may also occur, if the machine is worked
at a reduced workload after an extended period of
a heavier workload. To avoid false alarms, turn the
machine off rather than idling for extended periods.
Transport Operation
Make sure the cutting units are in the full up position.
Set the shift selector in No. 2 if conditions will permit
faster ground speed. Shift to No. 1 and operate at
slower ground speeds in rough or hilly areas. Use the
brakes to slow the machine while going down steep
hills to avoid loss of control. Always approach rough
areas at a reduced speed (shift selector in No. 1), and
cross severe undulations carefully. Familiarize yourself
with the width of the machine. Do not attempt to pass
between objects that are close together so that costly
damage and down time can be prevented.
Inspection and Cleanup After
Mowing
At the completion of the mowing operation, thoroughly
wash the machine with a garden hose without a nozzle
so excessive water pressure will not cause contamination
and damage to the seals and bearings. After cleaning,
inspect the machine for possible hydraulic fluid
leaks, damage or wear to hydraulic and mechanical
components, and the cutting units for sharpness.
Also, lubricate the mow and lift pedal and brake shaft
assembly with SAE 30 oil or spray lubricant to deter
corrosion and help keep the machine performing
satisfactorily during the next mowing operation.
27
- Quick Links:
- Schematics
Hide quick links:
Advertisement
Chapters
Table of Contents
