Labels DIP Switch Tables Serial Parallel SW Function SW Function 1-1 Data receive error Ignored Prints “?” 1-1 Auto line feed Always Always disabled enabled 1-2 Receive buffer 45 bytes 4 KB capacity 1-2 Receive buffer 45 bytes 4 KB capacity 1-3 Handshaking XON/XOFF...
Page 3
Neither is any liability assumed for damages resulting from the use of the information contained herein. Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation’s operating and...
The connection of a non-shielded printer interface cable to this printer will invalidate the EMC standards of this device. You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to operate the equipment.
Page 5
Do not allow foreign matter to fall into the equipment. Penetration by foreign objects may lead to fire. If water or other liquid spills into this equipment, unplug the power cord immediately, and then contact your dealer or a Seiko Epson service center for advice. Continued usage may lead to fire. CAUTION: Do not connect cables in ways other than those mentioned in this manual.
Drivers, utilities, and manuals can be downloaded from one of the following URLs. For customers in North America, go to the following web site: http://www.epsonexpert.com/ and follow the on-screen instructions. For customers in other countries, go to the following web site: http://www.epson-pos.com/ 4 TM-H6000III User’s Manual...
Do not use paper rolls that have the paper glued or taped to the core because they may cause a paper jam. To prevent paper jams, make sure that nothing obstructs paper coming out of the paper exit, and do not pull the paper out of the printer. TM-H6000III User’s Manual 5...
English Installing the Ribbon Epson recommends the use of genuine Epson ribbon cassettes. Turn on the printer. Turn the knob on the ribbon cartridge. Open the front cover of the printer, and insert the new ribbon. Turn the knob 2 or 3 times and check the ribbon position.
Turn off the printer and check for a paper jam. The autocutter is jammed or the roll paper cover will not open. Turn off the printer and open the unit cover. Then turn the knob until you see a pin in the opening. knob TM-H6000III User’s Manual 7...
Wait until the SLIP LED flashes. Then insert the check face up with the right side of the check against the right side of the paper guide as far as it will go. Be sure that the MICR characters are on the right. MICR characters on this side face up 8 TM-H6000III User’s Manual...
MICR reader with the display device in place. Make sure that the printer is not subjected to any impact or vibration when it is performing a MICR reading. TM-H6000III User’s Manual 9...
Page 12
Note: Do not open the unit during printing. Insert the ribbon into the printer in the position shown and turn the knob again to seat the ribbon. Then close the printer. 10 TM-H6000III User’s Manual...
English Epson Ecology Label This product is in compliance with the Epson ecology label requirements. Please see the following link for detailed information on label criteria: http://www.epson.co.jp/e/ TM-H6000III User’s Manual 11...
Page 14
Receipt: MTBF: 360,000 hours, MCBF: 72 million lines Slip: MTBF: 180,000 hours, MCBF: 18 million lines Overall dimensions 185 × 186 × 298 mm {7.28 × 7.32 × 11.73"} (H × W × D) Mass Approximately 5.3 kg {11.7 lb} 12 TM-H6000III User’s Manual...