Canon GP200 Service Manual page 410
Hide thumbs
Also See for GP200:
- Installation instructions (4 pages) ,
- Online manual (877 pages) ,
- Service manual (458 pages)
Table of Contents
Advertisement
5. INSTALLATION
11-5)Check to make sure that the notation of the
Keypad-A1 is as follows, and disconnect the
Keypad-A1.
Figure 5-520
12) Attach the switch settings label to the upper
cover 5; then, record the setting of each
switch on the label.
5
7
Figure 5-521
13) Fix the upper cover in place using two screws
7.
When doing so, make sure that the cable of
the power supply unit is held in position on the
cable guide inside the unit, and it is not
trapped by the upper cover.
14) To connect the Control Card Printer A-1, con-
nect it to the connector (J4) of the Copy Data
Controller-A1. (As necessary, use a relay
cable.)
5–42
COPYRIGHT © 1996 CANON INC.
Download service manual and resetter printer at http://printer1.blogspot.com
7
6
15) If the entire length of the cable is inside the
16) Fix the cable connected to the Copy Data
17) Check to make sure that the cable is not
CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 5-522
Copy Data Controller-A1, end the work.
Attach the petty-pull 8 on the right bottom of
the copier's rear.
8
Figure 5-523
Controller-A1 to the petty-pull.
trapped by the casters of the copier or the
sorter.
J4
- Quick Links:
- Names of Parts
Hide quick links:
Advertisement
Chapters
Table of Contents
