Page 1
REVISED.01 SERVICE MANUAL DIGITAL VIDEO DVD VIDEO RECORDER D-R5SC D-R5SU The above models are classified as green products (*1), as indicated by the underlined serial numbers. This Service Manual describes replacement parts for the green products. When repairing these green product(s), use the part(s) described in this manual and lead-free solder (*2).
Page 2
Hazardous Substances. From July 1, 2006, the RoHS Directive will prohibit any marketing of new products containing the restricted substances. Increasing attention is given to issues related to the global environmental. Toshiba Corporation recognizes environmental protection as a key management tasks, and is doing its utmost to enhance and improve the quality and scope of its environmental activities.
Page 3
LASER BEAM CAUTION LABEL When the power supply is being turned on, you may not remove this laser cautions label. If it removes, radiation of a laser may be received. PREPARATION OF SERVICING Pickup Head consists of a laser diode that is very susceptible to external static electricity. Although it operates properly after replacement, if it was subject to electrostatic discharge during replacement, its life might be shortened.
SAFETY NOTICE SAFETY PRECAUTIONS LEAKAGE CURRENT CHECK Measure the AC voltage across the 1500 Ω resistor. Plug the AC line cord directly into a 120V AC outlet (do not use an isolation transformer for this check). Use an The test must be conducted with the AC switch on and AC voltmeter, having 5000 Ω...
CONTENTS 1. LOCATION OF MAIN PARTS 1-1. Location of Main Parts 1-2. Location of PC Boards 2. WIRING CONNECTION DIAGRAM 3. PRINTED WIRING BOARD AND SCHEMATIC DIAGRAM 4. BLOCK DIAGRAMS 4-1. MPEG & SYSTEM Block Diagram 4-2. Power Supply Block Diagram 5.
1. LOCATION OF MAIN PARTS 1-1. Location of Main Parts RAM DRIVE Fig. 1-1-1 1-2. Location of PC Boards Power Switch PC board Digital PC board AV Tuner Unit PC board DV/AV Input PC board Front Display PC board Power PC board Fig.
2. WIRING CONNECTION DIAGRAM After the servicing is complete, return the wiring to its original state by using the diagram below as a reference. AV Tuner Unit PC board W301 W303 Digital PC board W104 Tape W802 W501 Tape W106 Power PC board Tape W105...
3. PRINTED WIRING BOARD AND SCHEMATIC DIAGRAM W802 CN802 FLAT WIRE 2.54 9P CN302 ON/OFF 5V ON/OFF 5V +3.3 V +3.3 V +3.3 V +3.3 V Power AV-TUNER ON/OFF 5V ON/OFF 5V AP+12 V AP+12 V AN-12 V AN-12 V +33 V +33 V CN301...
4. BLOCK DIAGRAM 4-1. MPEG & SYSTEM Block Diagram Digital Audio Out 128M SDRAM WM8776 IC504 J502 IC514 IC502 128M SDRAM 128M SDRAM L OUT IC507 Video FRONT 4558 R OUT 128M SDRAM Video IC503 32M FLASH CV BS IC511 IC513 2/2 BA7607 REAR...
6. PC BOARDS 6-1. DV/AV Input PC Board Fig. 6-6-1 DV/AV Input PC Board (Top side) Fig. 6-6-2 DV/AV Input PC Board (Bottom side) 6-2. Power Switch PC Board Fig. 6-6-3 Power Switch PC Board (Top side) Fig. 6-6-4 Power Switch PC Board (Bottom side)
SPECIFICATIONS Power requirement during operation Power requirement at standby 1.3W Power supply 120V AC, 60 Hz Mass 3.5kg External dimension Width 430 x Height 62 x Depth 302mm Incoming channels TV : 2-69CH, Cable : 1-125CH Antenna input/output terminal VHF/UHF : 75Ω, RF Connector Signal system Standard NTSC Color TV system Laser...
Page 33
1-1, SHIBAURA 1-CHOME, MINATO-KU, TOKYO 105-8001, JAPAN...