IMPORTANT SERVICE GUIDE 3 MODE SWITCH (PROGRAM SWITCH) ASSEMBLY POINT 1) When installing the ass’y full deck on the Main PCB, be sure to align the assembly point of mode switch. ASSEMBLY POINT Fig. 1 3 HOW TO EJECT THE CASSETTE TAPE (If the unit does not operate on condition that tape is inserted into housing ass’y) 1) Remove the Holder Worm Œ...
Page 3
Alternatively, wear a discharging Wrist-strap device. (Be sure to remove it prior to applying power--this is an electric shock precaution.) Samsung Electronics...
Page 4
Always inspect for pinched, out- of-place, or frayed wiring. Do not change the spacing between components and the printed circuit board. Check the AC power cord for damage. Make sure that leads and components do not touch thermally hot parts. Samsung Electronics...
3) When replacing the cylinder ass’y, be sure to adjust the “X-Point” and “Head switching adjustment”. 4) Among Samsung VCR remote control used for adjustment as a accessory, only the remote control that has figures buttons (0 ~ 9) is available for all adjustment regardless of chassis.
Page 6
Alignment and Adjustment 2-1-2 SW718 (TEST) location for adjustment mode setting PRESS Fig. 2-2 Main PCB (Top View) Samsung Electronics...
2) Press the “SW718 (TEST)” button on Main PCB to 6) Turn the Power off. set the adjustment mode. (See Fig. 2-2) 3) Press the “5” button of remote control then adjustment is operated automatically. (See Fig. 2-1) Samsung Electronics...
Important safety notices : Components identified with the mark have the special characteristics for safety. When replacing any of these components. Use only the same type. Block Identification of Main PCB Samsung Electronics...
Schematic Diagrams 5-18 Front A/V Jack/Shuttle F-A/V JACK APPLICATION MODEL ; SV-637B/630G/D620K/D600/626I ONLY SHUTTLE F-AV JACK APPLICATION MODEL ; SV-435G/D80K/D30K/A90G(HCII) ONLY 5-20 Samsung Electronics...