Brother MFC-7840W Quick Setup Manual page 42
Hide thumbs
Also See for MFC-7840W:
- User manual (192 pages) ,
- Network user's manual (151 pages) ,
- Quick setup manual (52 pages)
Table of Contents
Advertisement
STEP 2
Installing the Driver & Software
5
The machine searches for an access point that
supports SecureEasySetup™,
Wi-Fi Protected Setup™ or AOSS™ for 2
minutes.
Setting WLAN
6
If the LCD shows Connected, the machine
has successfully connected to your router or
access point. You can now use your machine
in a wireless network.
If the LCD shows Setting WLAN,
Connecting SES (Connecting WPS or
Connecting AOSS), then Connection
error , the machine has not successfully
connected to your router or access point. Try
starting from 4 again. If the same message is
indicated again, reset the machine back to the
default factory settings and try again. For
resetting, see Restoring the network settings to
factory default on page 45.
If the LCD shows Setting WLAN, then
Connection error or Incorrect Mode, a
session overlap or connection failure has been
detected (See the Note below). The machine
has detected more than 2 routers or access
points on your network that have the
SecureEasySetup™, Wi-Fi Protected Setup™
mode or the AOSS™ mode enabled. Make
sure that only one router or access point has
the SecureEasySetup™ mode, Wi-Fi
Protected Setup™ mode or the AOSS™ mode
enabled and try starting from 4 again.
Note
LCD messages when using the
SES/WPS/AOSS control panel menu
Setting WLAN
Connecting
SES/WPS/AOSS
Connection error
Incorrect Mode
Wireless setup is now complete. To install
the MFL-Pro Software suite, continue to
step 7.
40
Searching or accessing the
access point and
downloading settings from
the access point.
Connecting to the access
point.
Connection failed. (If it is
shown after the LCD shows
Connecting
SES/WPS/AOSS.)
Session overlap is
detected.
Session overlap is
detected.
7
Turn on your Macintosh
8
Put the supplied CD-ROM into your CD-ROM
drive.
9
Double-click the Start Here OSX icon to install.
Follow the on-screen instructions.
Note
Please see the Software User's Guide on the
CD-ROM if you want to install the PS driver.
10
Choose Wireless Network Connection, and
then click Next.
11
Click on the Checked and confirmed check
box, and then click Next. Follow the on screen
instructions.
Please wait, it will take a few seconds for the
software to install. After the installation, click
Restart to finish installing the software.
®
Macintosh
®
.
Advertisement
Table of Contents
