Epson L1300 Start Here page 3
Hide thumbs
Also See for L1300:
- User manual (86 pages) ,
- Programming manual (82 pages) ,
- Brochure & specs (4 pages)
Advertisement
Q
If any ink remains in the ink bottle after filling the ink tank up to the
upper line, install the cap securely and store the ink bottle upright
for later use.
將墨水填充至大容量墨水槽的最高標示線後，如果墨水瓶內有剩
餘墨水，請拴緊瓶蓋並直立存放墨水瓶，以供日後使用。
Guide to Control Panel
控制面板說明
Turns the product on/off.
P
開啟O/O關閉印表機的電源。
Feeds paper into the product and then ejects it to clean.
Resumes printing after an error.
將紙張饋入印表機，然後退出紙張以進行清潔。在發生錯誤
b
後繼續列印。
To perform print head cleaning, press for 3 seconds until the P
light starts flashing.
H
若要執行印字頭清潔，請按住三秒，直到OPO燈號開始閃爍。
Cancels a print job or stops printing.
+
取消列印工作或停止列印。
Print Quality Help
列印品質說明
Q
If you see missing segments or broken lines in your printouts, try
the following solutions.
如果列印成品出現遺漏部分或斷線，請嘗試以下解決方法。
A
Print a nozzle check pattern by turning on the product while pressing b. If you
notice any missing segments or broken lines as shown in (b), go to step B.
按下ObO的同時開啟印表機電源，列印噴嘴檢查表單。如果發現任何遺漏部
分或斷線O(如圖O(b)O所示)，請前往步驟OB。
(a)
(b)
B
Run the print head cleaning by pressing H for 3 seconds until the P light is
flashing.
按住OHO3 秒直到OPO燈號閃爍，以執行印字頭清潔。
Q
The cleaning uses some ink from all tanks, so run the cleaning only
if quality declines on your prints.
清潔程序會使用到所有大容量墨水槽中的部分墨水，因此僅在
列印成品的列印品質降低時，再執行清潔程序。
Error Indicators
錯誤指示燈號。
Q
If the product stops working and the lights are on or flashing, use the following table to diagnose and solve the problem.
若印表機停止運作且燈號亮起或閃爍，請利用下表診斷並解決問題。
: on / 亮起 /
: flashing / 閃爍 /
No paper is loaded, or multiple sheets were fed at the same time. Load paper in the rear paper feed correctly and press b.
沒有放入紙張，或後方進紙槽一次饋入太多紙張。請將紙張正確地放入後方進紙槽，並按下ObO鍵。
The paper has jammed in the product. Follow steps A to D in "Clearing Paper Jam" section to remove paper and resume printing.
Or for L1300, when you start printing, the printer cover is open. Close the printer cover. You can cancel your print job by pressing +.
印表機發生夾紙。請參考「清除夾紙」單元的步驟OAO至ODO移除紙張並恢復列印。若為 L1300，表示在您開始列印時印表機護蓋被
打開。請闔上印表機護蓋。您可按下O+O取消列印工作。
Fatal error. Turn the product off and then back on. If this does not clear the error, turn the product off and check inside the product for
jammed paper or foreign objects. See the "Paper Jam" section to remove paper.
嚴重的錯誤。請重新開啟印表機的電源。如果仍未清除此錯誤，請關閉印表機的電源，檢查內部是否出現夾紙或異物。請參考「夾
紙」單元移除紙張。
Initial ink charging may not be complete. Follow steps A to L in section 2 to complete initial ink charging.
初次墨水設定可能未完成。請依照單元 2 的步驟OAO至OLO完成初次墨水設定。
: off / 熄滅 /
Advertisement
