Network Settings; Standard - Sharp MX-3070N User Manual

Hide thumbs Also See for MX-3070N:

Table of Contents

SYSTEM SETTINGS►SYSTEM SETTINGS

Network Settings

Select the minimum required settings for the machine connection to the network.

Connection Type

Use this setting to switch between [Wired Only], [Wired+Wireless (Access Point Mode)] or [Wireless (Infrastructure

IPv4 Settings

When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine.

Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration

Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not necessary to manually enter an IP

• If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes,

printing will not be possible.

• If the machine is used on a TCP/IP network, be sure to enable the

IPv4 Address

Enter the IP address of the machine.

Enter the IP subnet mask.

Default Gateway

Enter the default gateway address.

IPv6 Settings

When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP address of the machine.

Enable this setting.

Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol) v6.

When this setting is enabled, it is not necessary to manually enter an IP address.

Manual Address/Prefix Length

Enter the IP address and the prefix length (0 to 128) of the machine.

Default Gateway

• If DHCPv6 is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing

will not be possible.

• If the machine is used on a TCP/IP network, be sure to enable the

• In an IPv6 environment, the machine can use LPD or IPP protocol.

"TCP/IP (page

7-134)" below.

Table of Contents

Mx-3570n Mx-4070n