Sharp FO-2950M Operation Manual page 133
Hide thumbs
Also See for FO-2950M:
- User manual (220 pages) ,
- Operation manual (152 pages) ,
- Service manual (5 pages)
Table of Contents
Advertisement
MEMORY IS FULL
MEMORY PRINTING
NO DATA
NO # STORED
OFF HOOK
ON HOOK DIAL
OUT OF PAPER
PAPER JAMMED
SEND READY
REPLACE TONER
SEARCH DIAL
The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible (an
additional message will indicate the problem), resolve
the problem so that printing can continue (see
Substitue Reception to Memory in Chapter 3). If you
are attempting to transmit by automatic dialing, see If
the memory becomes full in Chapter 2.
The fax is preparing to or printing out a document
from memory.
This appears if you attempt to search for an
automatic dialing number when none have been
stored.
You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn't been programmed (a full
number hasn't been assigned to it).
This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
The SPEAKER key has been pressed and the fax
machine is waiting for you to dial.
You are out of printing paper (or the paper release
lever is open). Load paper as explained in Loading
Printing Paper in Chapter 1.
The printing paper is jammed. See the following
section, Clearing Paper Jams.
A document has been loaded and the fax machine is
waiting for you to begin faxing or copying.
The toner cartridge must be replaced.
The HOLD/SEARCH key has been pressed. Press #
or * to search for an automatic dialing number, or
press the STOP key to return to the date and time
display. (See Searching for an auto-dial number in
Sending a Fax by Automatic Dialing in Chapter 2.)
Messages and Signals
131
Advertisement
Table of Contents
