Table of Contents
Advertisement
2.5.2 Installing Memory
The memory module (RIMM) will fit in only one orientation.
Do not touch the memory module's connectors. Handle the module
only by the edges.
P4T533-C
P4T533-C 184-Pin RIMM Sockets
1. Make sure that the notch keys in the module are aligned with the small
ribs inside the RIMM sockets.
MOUNTING NOTCH
EJECTOR
2. With the ejectors in the open position (as shown), push down gently but
firmly on the memory module until it snaps into place. The guides on the
socket's ejectors should go through the two mounting notches on the
module and the ejectors should close. If necessary, push the ejectors
inward to secure the module in place.
No hardware or BIOS setup is required after adding or removing memory.
18
®
RDRAM (with heat spreader)
RIBS (inside socket)
RIMM Sockets
RIMM with Heat Spreader
C-RIMM
NOTCH KEYS
(TOP VIEW)
Chapter 2: Hardware information
CONNECTORS
Hide quick links:
Advertisement
Table of Contents
