Table of Contents
Advertisement
26
SERVICE & DISASSEMBLY
UPPER SPRAY ARM MOUNT
1.
Replacing upper spray arm mount requires removal of cabinet. See section
on cabinet removal for detailed instructions.
2.
Set dishwasher upright and remove upper spray arm. The mount pushes
into the top of the tub with a rubber grommet. An arm on the mount holds it in
place to prevent turning during removal/installation of the upper spray arm.
3.
Reverse procedure for reassembly.
BOTTOM DOOR SEAL
Bottom door seal & screws
Figure 32
1.
While door is open, remove seal from seal mount on both sides and across
top of tub.
2.
To reinstall, begin inserting seal at either the left or right side. Place seal into
channel with wide side towards inside of tub. (See Figure 33)
Part of seal to
inside of tub
3.
Run seal up the channel, making sure seal is as deep in channel as possible.
4.
Do not stretch seal around corners, as leakage may occur as a result.
5.
The door seal is precut to the proper length and should not be cut.
6.
Once seal is properly in place, make sure seal is in channel completely.
Using a wide blade putty knife may help to push seal in place.
Door Seal
7.
Close door to make sure door seals. The door catch may need adjusting.
Figure 33
See the section on door latch/switch adjustment page 23 for detailed
instructions.
1. The bottom door seal is mounted to the bottom of the
inner door panel by five screws. Remove lower rack
and screws to remove seal.
2. Do not overtighten screws when reinstalling.
DOOR SEAL
- Quick Links:
- Troubleshooting Guide
- Electrical Diagram
Hide quick links:
Advertisement
Table of Contents
