Table of Contents
Advertisement
Available languages
Available languages
Interrupting a programme and changing
the options
You can change only some options before they
operate.
1. Touch
.
The indicator of this button flashes.
2. Change the options. If you change any
option the Finish In option (if set) will be
disabled.
3. Touch
again.
The programme continues.
Cancelling a programme
1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water.
In this case, make sure that the
detergent is still in the detergent
compartment, if not fill the detergent
again.
Opening the door
While a programme (or the
appliance door is locked. The indicator
on.
CAUTION!
If the temperature and level of the
water in the drum are too high, you
cannot open the door.
To open the door during the first minutes
of the cycle (or when the
1. Touch the button
appliance.
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button
again. The programme (or the
continues.
At the end of the programme
• The appliance stops automatically.
12
for some seconds to
) operates, the
is
operates) :
to pause the
goes off.
)
• The acoustic signal operates (if it is
activated).
• In the display
comes on.
• The indicator of the button
• The door lock indicator
• You can open the door.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Press the button
deactivate the appliance.
• Close the water tap.
• Keep the door and the detergent drawer
ajar, to prevent the mildew and odours.
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent the
creases in the laundry.
• The indicator
drain the water.
• The door lock indicator
indicator of button
stays locked.
• You must drain the water to open the door.
Draining the water:
1. To drain the water.
• Touch the button
drains the water and spins with the
maximum spin speed for selected
washing programme.
• Alternatively, touch the button
change the spin speed and then touch
the button
water and spins. If you set
appliance only drains.
2. When the programme is completed and the
door lock indicator
open the door.
3. Press the button
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
AUTO-OFF option
The AUTO-OFF stand-by option automatically
deactivates the appliance to decrease the
energy consumption. All the indicators and the
display go off when :
goes off.
goes off.
for some seconds to
flashes to remind you to
is on. The
flashes. The door
. The appliance
to
. The appliance drains the
, the
goes off, you can
for some seconds to
www.zanussi.com
Advertisement
Chapters
Table of Contents
